8000060 Rev 3 19-Feb-19
TyconSystems.com
8
1.2. Install wind vane (If required)
Push the wind vane into the shaft. as shown in figure 5.
Tighten the set screw with as shown in figure 6
. Wind vane doesn’t
move as freely as the wind speed sensor. This damping effect is
helpful in keeping wind direction measurement steady.
Figure 5 Figure 6
There are four letters: "N", "E", "S" and "W" around the wind direction
sensor, representing direction North, East, South and West. The Wind
direction sensor must be adjusted so that the directions on the sensor
are matching the real location. A wind direction error will be introduced
if the wind direction sensor is not positioned correctly during
installation.
Summary of Contents for TP3000WC
Page 60: ...8000060 Rev 3 19 Feb 19 TyconSystems com 60 System Setting Alarm ...
Page 61: ...8000060 Rev 3 19 Feb 19 TyconSystems com 61 Max Min Day Max Min History ...
Page 62: ...8000060 Rev 3 19 Feb 19 TyconSystems com 62 Calibration ...
Page 63: ...8000060 Rev 3 19 Feb 19 TyconSystems com 63 Record History ...
