Tyco Electronics p5400 series, Operator'S Manual

Page: 40 / 135

MM-013994-001
39
8.7 ALERT TONES
The P7300 radio provides audible Alert Tones or “beeps” to indicate the various operating conditions (see
Table 8-4).
Table 8-4: Alert Tones
NAME TONE DESCRIPTION
Call Originate one short mid-pitched
OK to talk after pressing the push-to-talk button
Call Queued one high-pitched
Call queued for processing
Autokey one mid-pitched
Queued call received channel assignment
System Busy three low-pitched
System busy or unable to complete call
Call Denied one low-pitched
Radio is not authorized on the system or group
Carrier Control Timer five high-pitched/one long
low-pitched
PTT depressed for maximum length of time
Low Battery one low-pitched/one short
mid-pitched
Low battery
TX Low Battery Alert one low-pitched
After PTT - battery too low to transmit
8.8 TURNING ON THE RADIO
1. Power ON the radio by rotating the POWER ON-OFF/VOLUME knob clockwise. A short alert
signal (if enabled through programming) indicates the radio is ready to use.
2. The display shows the last selected system and group or a default system and group (depending on
programming).
3. Adjust the POWER ON-OFF/VOLUME knob to the desired volume level.
4. Select the desired system and group. The display indicates the current system and group names.
5. The radio is now ready to transmit and receive calls.
In the trunked environment, CC SCAN will be displayed if communication with the
system's control channel cannot be established. This may occur if, for example, the
radio is out of range of the trunking site. It may be necessary to move to another
location or select another trunking system to re-establish the control channel link for
trunked mode operations. CC SCAN is displayed on the group line until a control
channel is accessed.