29
http://www.TYAN.com
2.25 – Installing the Memory
Before attempting to install any memory, make sure that the memory you have is
compatible with the motherboard as well as the processor
*
. A Critical aspect to any system
build is whether you’re using the recommended memory for your specific motherboard. For
compatibility information, please check Tyan’s web site at:
www.tyan.com
z
Not all stepping of Intel CPU’s support the same type of memory speeds.
Consult with Intel for clarification.
The following diagram shows the common type of FBDIMM modules you may encounter:
AMB Only Heatsink.
Full-DIMM Heatsink Spreader (Recommended Solution)
Here are a few key points to note before installing memory into your Tempest i5000PW;
•
Intel processors support 64bit (non-interleaved) or 128bit (interleaved) memory
configurations.
•
16 pieces of 240-Pin FBDIMMs Sockets via two memory riser cards (M5382) with
8 FBDIMMs on each memory riser card. (The FBDIMM Riser Socket is for memory
riser cards use only.)
•
Always install memory beginning with FBDIMM Riser Socket 0 (please refer to
2.02 Board Parts, Jumpers and Connectors) and follow the order from the bottom
up.
•
At least ONE 240-Pin FBDIMM module must be installed for the system to turn on
and POST (power on self test).
•
Only Fully-Buffered DIMM memory modules are supported.
•
All installed memory will be automatically detected.
•
The Tempest i5000PW supports up to 64GB
*
.
*
Not validated at the time of print, subject to change.
