TYAN S2933, Manual

Page: 22 / 90

http://www.tyan.com
22
Processor Installation
The processor should be installed carefully. Make sure you are wearing an
antistatic strap and handle the processor as little as possible.
Follow these instructions to install your processor:
1. Place the PCB such that the socket cam side faces you. Make sure
the lever hook is on your top-left side.
2. Use your right thumb to push the latches of PnP cap and remove the
PnP cap from the load plate.
3. Use your left thumb and forefinger to hold the lever hook, and then
pull it to the left side to clear the retention tab.
4. Rotate the lever to a fully open position.
5. Put your right thumb on the bottom-right side of the load plate to
open it.
6. Rotate the load plate to a fully open position.