22
http://www.tyan.com
Finishing Installing the Heatsink
After you finish installing the heatsink, attach the end wire of the fan (already be attached to the
heatsink) to the motherboard.
After you’re finished installing all the fans you can now connect your drives (hard drives, CD-ROM
drives, etc.) to your motherboard.
2.21 – Installing the Memory
Before attempting to install any memory, make sure that the memory you have is compatible with
the motherboard as well as the processor. For example, while PC1600 DDR modules are
compatible with all DDR based motherboards, they will not work if you are required to run the
motherboard and processor buses at 533MHz. For this, PC2100 DDR (DDR266) modules are
required. For important memory information, please check Tyan’s web site at:
www.tyan.com
for
recommendations.
Processor
DDR200 (PC1600)
DDR266 (PC2100)
Xeon 400MHz FSB
v
supported
v
supported
Xeon 533MHz FSB
X
unsupported
v
supported
The following diagram shows the types of RAM modules you may encounter depending on your
board:
DDR Registered ECC
v
supported
DDR Unbuffered ECC
X
unsupported
This diagram illustrates how to connect
fans onto the motherboard.
