24
http://www.tyan.com
3.3 – Chipset Configuration
Options such as graphics and memory settings can be altered in this section.
Graphics Aperture
32MB
64MB
128MB
256MB
512MB
None
Defines the size of system memory reserved
for AGP graphics data such as textures.
Usually, the higher the setting, the better
AGP performance, regardless of how much
actual RAM you have installed on your
motherboard.
SERR Signal Condition
None
Single bit
Multiple bits
Both
Toggles the ERR signal in the listed
conditions. Leave at default setting.
ECC Config
Disabled
EC (Single bit)
ECC (multiple bits)
ECC Scrub
Toggles memory correction.
EC – Error checking and status reporting
enabled. Data is not corrected.
ECC – EC but data is corrected.
ECC Scrub – ECC with memory contents
corrected after all reads with errors.
3.4 – Keyboard Configuration screen
Options related to keyboard setup can be altered in this section.
Boot up Num-Lock
Auto
On
Off
Toggles the Num-lock keyboard function to be
turned on at startup or be disabled at startup.
Keyboard auto-repeat
rate
30/sec
26.7/sec
21.8/sec
18.5/sec
13.3/sec
10/sec
6/sec
2/sec
Defines the rate at which characters are
repeated on screen when holding down keys on
the keyboard.
Keyboard auto-repeat
delay
1/4 sec
1/2 sec
3/4 sec
1 sec
Defines the delay when holding down a key
before characters begin to repeat.
KB error
This option toggles whether the system will pause if a keyboard error
is detected or continue to boot.
3.5 – I/O Configuration
Options related to I/O setup can be altered in this section.
PS/2 Mouse
Toggles the PS/2 mouse port. Enabled will use system resources.
Floppy disk controller
Toggles the onboard floppy disk controller. Leave as Enabled or set
to Auto if you plan to use a floppy disk drive.
Serial Port A (..B)
Enabled
Disabled
Auto
Toggles the use of the onboard Serial Ports.
Enabling the ports will require system resources
such as IRQs.
