S2060 Tomcat i815e
15
INST
ALL
1. Setting Jumpers
Note:
There are no Jumper settings for CPU bus speed or clock multiplier on the
Tomcat i815e board. The Tomcat i815e is designed to automatically detect the
socketed Pentium III / Celeron CPU and its proper speed settings.
1-A. J15 External Pin Assignments
1-B. Power LED (J33)
Jumper J33 is a 3-pin ACPI LED
header. If you need a 2-pin Power
LED header, use jumper J15 above.
1-C. Clear CMOS and Reset Password (JP1)
If you have been locked out of your system because you forgot your password or set
the CMOS incorrectly, follow the instructions below.
1. Power off the system and unplug power cable from the motherboard.
2. Set jumper JP1 to pins 2 and 3.
3. Wait for 10 seconds, then return jumper JP1 to pins 1 and 2.
4. Plug in power cable and power on the system again.
By following this procedure, you will erase your password and reset the CMOS to the
BIOS defaults.
1-D. BIOS Flash TL (JP2)
By default, this jumper is set to
OPEN
(locked) position. Having the Top Lock (TL)
protection “locked” will allow normal system operation. Closing jumper JP2 (un-
locked) will allow the BIOS to be flashed.
NOTE: If the jumper JP2 is closed
(unlocked), and if failure occurs during a new BIOS flash, you run the risk of
rendering your entire system unbootable. The “backup” protection of the Boot
Block will be lost.
Pin
1
2
3
+5 VSB
LED YEL
Ground
VCC
LED GRN
t
l
u
a
f
e
D
t
e
s
e
R
1
P
J
2
-
1
3
-
2
VCC+
1
2
P ower LED+
Ground
3
4
Sleep LED+
Ground
5
6
P ower On/Off
Swit ch
7
8
P wr On/Off GND
IR +5V
9
10
NO CONNECT
IR RX
11
12
Ground
IR GND
13
14
NO CONNECT
IR T X
15
16
NO CONNECT
IR RX2
17
18
NO CONNECT
Infrared
HDD
LED
Reset
Switch
Pwr/Slp
LEDs
Power
(Sleep)
Switch
Close
Open
JP2
Unlock
Lock Flash TL
!
important!
J15,
J33
JP1 (clear CMOS)
JP2
