TYAN FT48B-B7100, Service Engineer'S Manual

Page: 8 / 86

8
http://www.tyan.com
·
Ensure that the voltage and frequency of your power source match the
voltage and frequency inscribed on the electrical rating label of the
equipment.
·
Do not install the system in or near a plenum, air duct, radiator, or heat
register.
·
Never use the product in a wet location.
Equipment Chassis
·
Do not block or cover the openings to the system.
·
Never push objects of any kind through openings in the equipment.
Dangerous voltages might be present.
·
Conductive foreign objects can produce a short circuit and cause fire,
electric shock, or damage to your equipment.
·
Lift equipment using both hands and with your knees bent.
Equipment Racks
To avoid injury or damage to the equipment:
·
Observe local occupational health and safety requirements and guidelines
for manual materials handling.
·
Do not attempt to move a rack by yourself; a minimum of two people are
needed to move a rack.
·
Do not attempt to move a fully loaded rack. Remove equipment from the
rack before moving it.
·
Do not attempt to move a rack on an incline that is greater than 10 degrees
from the horizontal.
·
Make sure the rack is properly secured to the floor or ceiling.
·
Make sure the stabilizing feet are attached to the rack if it is a single-rack
installation.
·
Make sure racks are coupled together if it is a multiple-rack installation.
·
Make sure the rack is level and stable before installing an appliance in the
rack.
·
Make sure the leveling jacks are extended to the floor.