Laser Welding Machine
Address: 18 South Liu Fang Yuan Road,Sintec Industrial Park, Wuhan Hubei, 430205 PR China
Tel: 0086 27 65523998 Mobile/WhatsApp/Wechat:0086-17371095681
Web:http://www.txtlaser.com/ ; E-mail: [email protected]
第
19
页
●
Materials: Several materials to be processed, 1 roll of insulating tape for
spare.
●
Personnel: Equipment operator: should be able to operate and use
computer.
3.3 Site and supporting facilities requirements
●
The ground is flat, not easy to get dust, far away from vibration sources,
and away from strong electromagnetic interference. better to have relative
Independent closed room, clean and dust-free with air conditioning. Keep the
ambient temperature at 15
°
C to 30
°
C, relative to Humidity <85%
(non-condensing).
●
Commonly used gases are: argon, nitrogen and other inert gases
(The gas needs to be filtered, dried and cooled by oil and water before it can
be connected to the φ6 quick socket at the back of the equipment)
Air pressure requirement≥0.8MPa
4 Switching process
4.1 Boot process
Before starting the machine, please make sure that the switch on the panel of
the device and the switch on the air switch are in the off position.
The dual temperature and dual control chiller must be filled with distilled water.
In winter or when the temperature is lower than 10 degrees, special antifreeze
for fiber lasers must be added (Clariant is recommended).
Note: When using this equipment, the whole machine must be grounded, and
