Document name/
文件名称
Battery Specification/
电池规格书
Product Model/
产品型号
BLP661
Document NO/
文件编号
RD-PSP-BLP661-01
Revision/
版本
01
Date/
日期
2018-01-03
Page/
页码
8/ 18
--- TWS Confidential ---
Form No.: TWS-IMS-2001-01--04c REV
：
C
7.2
Vibration/
震动
After charging the battery, and secure the battery on the top of
vibration table without distorting the battery. the vibration
should be a sinusoidal waveform with a logarithmic sweep
between 7 Hz and 200 Hz and back to 7 Hz traversed in
15minutes. This cycle should be repeated 12 times for a
total of 3 hours for each of three mutually perpendicular
mounting positions of the battery. One of the directions of
vibration must be perpendicular to the terminal face. /
电池
充满电后，将电池固定在振动台上，不可使电池变形。采
用正弦波进行振动，并以对数扫频方式在 15min 内从 7Hz
扫频到 200Hz 并返回到 7Hz。振动沿样品互相垂直的三个
方向（其中一个方向必须与样品正负极所在平面垂直）进
行，每个方向按上述对数扫频方式重复 12 次，振动 3h。
The logarithmic frequency sweep is as follows: from 7 Hz a
peak acceleration of 9.8m/s2 is maintained until 18 Hz is
reached. The amplitude is then maintained at 0.8 mm (1.6 mm
total excursion) and the frequency increased until a peak
acceleration of 78.4m/s2 occurs (approximately 50 Hz). A
peak acceleration of 78.4m/s2 is then maintained until the
frequency is increased to 200 Hz./
对数扫频方式如下：
7Hz～18Hz保持9.8m/s2的峰值加速度。将振幅保持在
0.8mm（位移为1.6mm）直至峰值加速度达到78.4m/s2（频
率约为50Hz）
。保持78.4m/s2的峰值加速度直到频率增长
到200Hz。
1.
The open circuit
voltage should not
be lower than 90%
of the initial
voltage. There
should be no
leakage, no rupture,
no fire and no
explosion./
电 池 开
路 电 压 不 小 于 规
格的
90%
。电池应
不起火、不爆炸、
不漏液。
2.
Battery thickness
variation rate
≤
5%
；
/
电 池 厚 度 变 化
≤
5%
。
3.
After the test, the
battery should
present no obvious
cosmetic
difference./
测 试
后，电池表面无明
显变化。
7.3
Shock/
冲击
Secure a battery on table top in each of the three mutually
perpendicular directions (X, Y and Z). Set the Peak
acceleration to 100 m/s2; Subject the battery to 40 to 80
times of shock per minute. Impulse duration is 16ms and
the total number of shocks is 1000±10 times. Take off the
battery from the test table, the appearance and the battery
voltage should meet the criteria. /
将电池平均按
X
、
Y
、
Z
相
互垂直轴向直接或通过夹具坚固在台面上，按下述要求调
好加速度、脉冲持续时间，进行碰撞试验：脉冲峰值加速
度
100 m/s
2
；每分钟碰撞次数
40
～
80
；脉冲持续时间
16ms
；
碰撞次数
1000
±
10
次。碰撞结束后将电池自实验台取下，
电池外观及电池电压应符合判定标准。
1.
No obvious
cosmetic damage,
no leakage, no
smoke or no
explosion./
电池无
明显破损，不冒
烟、不爆炸、不漏
液。
2.
Battery voltage
should not be lower
than 3.6V./
电池电
压不低于
3.6V
。
7.4
Drop/
跌落
Drop a battery from a height of 1 m to concrete floor. Each
battery face is subject to one fall, total six tests. /
将电池从 1m
处自由落体跌落于混凝土板上，每个面各跌落 1 次，总共
6 次。
No drop test request./
无跌落要求
8
Safety and protection performance/
安全保护性能