MOUNTING LEGS TO THE STOVE BODY
Insert the leg buckles into the holes located on the base of the stove. Fasten the legs using the screws (1
screw per leg) and tighten with a Phillips head screwdriver (Fig. 3)
Fig.3
STOVE LOCATION
When choosing a location for your new stove, follow the instructions listed in the <IMPORTANT
INSTRUCTIONS> section in page 2.
Cold climate installation recommendation: When installing this unit against a
non-insulated exterior wall or chase, it is mandatory that the outer walls be insulated to
conform to applicable insulation codes.
ELECTRICAL CONNECTION
A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will
be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation. The unit comes standard with 6-ft. (1.83 m) three-wire
cord, exiting from the rear of the fireplace.Do not exceed the current rating of the current tap. Always plug
heaters directly into a wall outlet/ receptacle. Never use with an extension cord or relocatable power tap
(outlet/ power strip).
E-4
Before beginning installation of the product, make sure all parts are present. Compare parts with
package contents list and diagrams above. If any part is missing or damaged, do not attempt to
assemble, install, or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly: Phillips head screwdriver (not included)
PREPARATION
