11
OPERATING INSTRUCTONS
BEFORE LIGHTING THE UNIT:
•
DO NOT ATTEMPT TO LIGHT THE BREAKFAST CLUB IF YOU SMELL GAS.
•
WARNING! IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED. If
not properly installed, gas may leak outside of the burner that could lead to fire, potential damage
to your appliance and bodily injury.
Inspect the gas supply piping or hose prior to turning the gas
ON. If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use. The replacement
pressure regulator and hose assembly must be the type specified by the manufacturer. Do not use the
appliance if the odor of gas is present. The pressure regulator and hose assembly supplied with the units
must be used.
•
If the unit is LP, screw the regulator and hand tighten to the valve of the cylinder and leak check the
hose and regulator connections with a soap and water solution before operating the appliance.
(Reference page 10 for leak test procedure)
•
Always keep your face and body as far away as possible when lighting.
•
Refer to spiders and insects warning and procedure under the cleaning and maintenance page of this
manual.
Lighting Instructions (Top Burners)
1.
Remove the covers from the Top Burners.
2.
Ensure the gas supply cylinder valve is closed and the burner
knobs are set to the off position.
3.
Open the valve on the gas supply cylinder.
4.
Press in and rotate one of the top burner knobs
counterclockwise to the “HI” position and keep it pressed in.
You should here a continuous clicking sound indicating that a
spark is being provided to the burner. (If clicking sound is weak,
replace battery.)
5.
If ignition does not take place within 4 seconds, turn the burner
knob to the off position, leave the cover off, and wait 5 minutes
to repeat lighting procedure.
6.
Repeat steps 4-6 to light the second side burner.
Lighting Instructions (Griddle Plate)
1.
Remove the cover from the griddle plate.
2.
Ensure the gas supply cylinder valve is closed and
the burner knob is set to the off position.
3.
Ensure that the grease tray is completely installed.
4.
Open the valve on the gas supply cylinder.
5.
Press in the switch on the right marked with the
symbol.
6.
Rotate the thermostat knob counterclockwise to the
desired temperature setting, a burner on light should
glow when the griddle thermostat is turned on until
it reaches the temperature the thermostat knob was
set to.
