OPERATION & PROGRAMMING
11
TITLE EDIT
*This title edit menu can be used in OSD Setup/Pattern/Scan/Preset/Area Title commonly.
To edit a title:
1.. Use the joystick to position the cursor beside TITLE.
2. Move the joystick right. The following appears on the monitor.
3. Use the joystick right, left, up and/or down to select a character. Press [TELE] button or twist the joystick
clockwise to input a character.
4. Press [WIDE] button or twist the joystick counterclockwise to delete a character.
5. Follow the directions displayed on the monitor.
6. When the label is completed, press [ENT] or [IRIS OPEN] to return to the previous menu.
7. To cancel editing a title, press [CLR] or [IRIS CLOSE] to return to the previous menu.
TITLE:
ABCDEFGHIJKLMNOP
QRSTUVWXYZabcdefg
hijklmnopqrstuvwx
yz0123456789<>/ -:
■
Select: <MOVE>
■
Save: <ENT> <OPEN>
■
Exit: <CLR> <CLOSE>
Check points before operation
Before power is applied, please check the cable carefully.
The camera ID of the controller must be identical to that of the target camera. The camera ID can be checked by reading
Rotary switch of the camera.
If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.
If you change the camera ID by changing Rotary switch, the change will be effective after you reboot the camera.
Since the operation method can be different for each controller available, refer to the manual for your controller if camera
can not controlled properly. The operation of this manual is based on the standard pelco controller.
NOTE.
1. Version can be changed by system upgrade.
2. This manual is written by using supplied controller.
3. Temperature can be changed by outside environment.
OSD Display of Main Screen
- Camera ID: If the camera ID was saved by rotary switch as you want, the camera ID will be
displayed on main screen.
- When you move the joystick of controller, the angle of Pan/Tilt will be displayed on main screen.
ID : 001
<180.01,230.00>
Dome ID
The angle of pan/tilt
