Programming the Remote Control
The F box’s remote control can be programmed to operate certain TVs and DVD players.
Follow the procedure below to programme the remote control.
Find the 4 digit code for brand of TV or DVD player from the brand codes, starting on page
1.
28.
If your brand is not included in the list or the codes for your brand do not operate your equipment, refer to the
following page for an automatic method of programming the remote control.
2.
If you want to programme the remote control to operate a TV:
Press the
[TV]
button.
If you want to programme the remote control to operate a DVD player:
Press the
[DVD]
button.
Press and hold the
3.
[ ]
button for approximately 3 seconds. The
[TV]
/
[DVD]
button flashes
twice.
Use the
4.
[0]
-
[9]
buttons to enter the 4 digit code for your brand. The
[TV]
/
[DVD]
button flashes
when every digit of the code is entered.
If a valid code has been entered, the
5.
[TV]
/
[DVD]
button will flash twice, quickly.
Check that the remote control operates your equipment by pressing the
6.
[
1
]
button. If not,
repeat the above procedure and try another code for your brand.
The codes you enter may be lost if weak batteries are not replaced immediately. Even if your TV/DVD brand is
listed in the code table, in some instances it may not be possible to operate all of the available functions.
Automatically Programming the Remote Control
If your TV or DVD brand is not included in the code list, or the brand codes in the list do not
operate your equipment, it may still be possible to programme the remote control to operate
your equipment.
If you want to programme the remote control to operate a TV:
1.
Press the
[TV]
button.
If you want to programme the remote control to operate a DVD player:
Press the
[DVD]
button.
Press and hold the
2.
[ ]
button for approximately 3 seconds. The
[TV]
/
[DVD]
button flashes
twice.
Use the
3.
[0]
-
[9]
buttons to enter the code ‘991’. The
[TV]
/
[DVD]
button flashes when every
digit of the code is entered. If the code has been entered correctly, the
[TV]
/
[DVD]
button will
flash once, quickly.
Press the
[
1
]
button and note whether the remote control switches off your TV/DVD player.
If the remote control switches off your TV/DVD player:
The remote control has found your code. Press the
[ ]
button to save.
If the remote control does not switch off your TV/DVD player:
Press the
[CH+]
button then press the [
1
] button. Repeat this until the remote control
switches off your TV/DVD. The remote control has found your code. Press the
[ ]
button
to save.
28
