C2-7000 S
ERIES
O
PERATION
M
ANUAL
38
Genlock
The output video will be “Genlocked” to the selected lock
source. The output signal will be synchronous to the input
sync and adjustable but there will still be no lock source
visible.
Lock & Mix
The output video will be locked to the selected source, the
syncs will be locked (but with an additional internal video
processing delay) and the background for the output will be
that of the Lock source (unless foreground and background
are swapped).
In both Genlock and Lock & Mix modes the source selected for the lock input
determines the resolution of the Output image. The output resolution for the
entire image can be no different than the resolution of the lock source. All
synchronization signals are re-generated within the unit so they may look
slightly different when compared on an oscilloscope to the original source.
Before turning the Lock feature on, you first must select a
valid Lock source. Some units may not have all Lock
sources available, depending on hardware limitations – see
Specifications for details of limitations on your unit.
Your unit can handle a very wide array of inputs and convert them all to a
single output signal with defined characteristics. This output resolution will
remain in place until changed or it may be overridden by the lock mode and
source.
The top line of the display will show the current output resolution selected.
Some units will have a limited number of output resolutions depending on
their function (e.g. Down Converters are more limited than Video Scalers).
This menu item allows you to select the type of signal output your unit will
provide. Types of output vary depending on the resolution selected and
include various types of component signals Y/R-Y/B-Y or YPbPr, the full
range of RGB type signals RGBHV, RGBS and RGsB (Sync on green).
This menu item is only available on certain units with an SDI output and when
locking to a CV or YC input. An internal de-jitter circuit ensures that the SDI
output has a low jitter over the full 10Hz to 100kHz range, even though the CV
or YC input may have a high jitter. However, this is not always compatible
with a CV/YC output where the colour sub-carrier should not be de-jittered
1024 x 768 60Hz
Output res. [28]
Adjust outputs
Output type [RGBHV]
Adjust outputs
Optimize for SDI [On]
Summary of Contents for C2-7000 Series
Page 120: ......
