1T-C2-511 A
ND
1T-C2-520 O
PERATION
M
ANUAL
19
7
FRONT PANEL CONTROLS
7.1
Button controls
The following buttons are available on the front of the unit include all or some of the
following:
Button
Button Function
Menu
Activates the on screen display and allows for menu control
This displays the previous menu item
This displays the next menu item
Input
Input select (1T-C2-520 only). Press to cycle thru the input
sources.
Standby
Hold in to put the unit into Standby (power-save) mode. Hold in
briefly to come out of Standby mode.
7.2
Default settings
When your unit powers up for the first time, the LED next to the Menu button will
illuminate showing that the unit is operational. If there is no valid input, the 1T-C2-
5111 will output the OSD in 720p, and on 1T-C2-520 will output the OSD in 525i
resolution. If there is a valid input then the output signal will be present on all
outputs simultaneously. In the same way if the SDI video input has audio present on
channels 1 and 2, then these will be output on both AES and analog stereo outputs,
else they will be muted.
7.3
Control
The on-screen display (OSD) is controlled from the front panel using the MENU,
and
buttons on the front panel. Pressing the MENU button once will activate the
OSD. Holding the MENU button in for a short while will then close the OSD.
While the OSD is active, use the
and
arrowed keys to change where you are in
the menu.
You can edit values in square brackets ‘[ ]’ by pressing the MENU button once (you
will note that the brackets surrounding a particular parameter’s value will begin to
flash). Change the value by using the
and
buttons to decrease and increase the
value respectively. Then finalize your adjustment by pressing the MENU button once
more.
A few menu items have multiple parameters within an individual menu selection. In
those cases, you can adjust one item, and then move to the next etc.
Holding the MENU button in for a few seconds stores all changes
in memory. Unless you intentionally change it again later, the
adjustment will remain even after power is removed from the unit.
