TV Logic Viewfinder VFM-056W, Operation Manual

Page: 9 / 32

V
iewfinder Monit
or 9
5. Controls & Functions
SIDE
REAR
t
PGM (Mini HDMI)
- This terminal is used to upgrade the firmware
or color calibration made by TVLogic.
t
AUDIO OUT (Phone Jack)
- Used for Stereo Audio Output through Phone
Jack. (video signals with embedded audio only)
t
Knob (Rotary Encoder)
- Scroll up and down the Knob to move the
cursor and press the Knob to select an item.
- Used to move within the menu when OSD
menu is activated, and is also used to decrease
or increase the value of the selected feature.
- When OSD menu is inactivated, press the
knob to adjust the value of Brightness, Contrast,
Chroma, Aperture or Volume.
- In Pixel to Pixel mode, scroll the knob to
move the displayed area from clockwise or
counterclockwise.
- In Luma(Y’) Zone Check mode, it is used to
adjust the value.
- Press the knob to select the main menu and
sub menus.
t
SDI-IN (BNC)
- Select SD/HD/3G-SDI Signal.
t SDI-OUT (BNC)
- SD/HD-SDI Signal Output which is input
through [SDI-IN] terminal.
t HDMI IN (HDMI)
- Select HDMI Signal which is input through
[HDMI] terminal.
t CVBS/Y/S-Y (RCA)
- Select CVBS (Composite Video), Component
Y’ or S-VIDEO Y’ signals.
t
Pb/S-C (RCA)
- Select Component Pb or S-VIDEO C’ signals.
t Pr (RCA)
- Select Component Pr signal.
t
DC POWER IN (DC Adapter)
- DC power input terminal for DC 12V.
t
BATTERY/TALLY (XLR 4P)
- Tally Signal In/Out
- Battery Power Input DC 12V
* Rated Power Input : DC 6~12V (0.7~1.5A)
<Warning!!>
When using the product make sure to ground
before connecting the input signal line.
The unit may not operate properly if the input
line is connected before the GND is connected.
t
[
㙾
FUNC./
㙾
㚃㚃㚃㚃㚃
FUNC. SEL.] Button
- Press the button for less than 2 seconds to
activate designated FUNCTION.
- Press the button for more than 2 seconds to
activate the Function Select menu. (Scan,
Aspect, H/V Delay, etc)
- After pressing the button for more than 2
seconds, the function which was selected
previously is displayed. Use the Knob to change
the function.
* Function Select button can be set in the main
menu [SYSTEM].
t [
㙾
MENU<EXIT>/
㙾
㚃㚃㚃㚃㚃
SOURCE] Button
- Press the button for less than 2 seconds to
activate the main OSD menu.
- Used to return from sub menu to main menu.
- Press the button for more than 2 seconds to
activate Input Select menu. (SDI, HDMI, CVBS,
S-Video, Component Video)
- Use the Knob to change the Input Signal.
Connector Composite Component S-Video
1 CVBS Y Y
2 No Con. Pb C
3 No Con. Pr No Con.