TV Logic Viewfinder VFM-056W, Operation Manual

Page: 13 / 32

V
iewfinder Monit
or 13
t
User Aspect Horizontal/User Aspect Vertical
- Activated only when [SCAN] mode is set to
[User Aspect] .
- User can adjust the Horizontal and Vertical size
of the screen.
- See section “Other Functions [2] User Aspect”
(page 21) for more information.
t
Pixel To Pixel Position
- Activated only when [SCAN] mode is set to
[Pixel-To-Pixel].
- When the resolution of the input video
signal(ex. 1920×1080) is higher than that of
the monitor(1280×800), only area equivelant to
1280×800 out of the 1920×1080 will be
displayed in the [Pixel to Pixel] mode.
* See section “Other Functions [1] Pixel to Pixel”
for more information.
t
3G Format (VFM-056WP Only)
- Used to select 3G-SDI A/B input format among
NORMAL MODE(AUTO - A 422 10BIT_YCbCr
50/60P), A 444 10/12BIT_YCbCr, A 444 10/12BIT_
RGB, A 422 12BIT_YCbCr, B 444 10/12BIT_YCbCr,
B 444 10/12BIT_RGB, B 422 12BIT_YCbCr, B 422
10BIT_YCbCr 50/60P.
- In NORMAL MODE, automatically detected
when Payload signal is contained.
t
Scan
- Used to change the Scan mode. Scroll up and
down the Knob and the mode will be changed
as the following sequence.
- [Zero Scan] -> [Over Scan] -> [Pixel-To-Pixel] ->
[User Aspect]
* See section “Other Functions [1]
Pixel to Pixel” on page 20 for more information.
# [USER ASPECT]: User can control the aspect
ratio by adjusting width and height of the
display.
- See section “Other Functions [2] User Aspect”
on page 21 for more information.
t
Aspect
- Used to change the display ratio between 4:3
and 16:9.
* Display ratio is fixed to 16:9 if the display ratio
of input signal is 16:9.
t
H/V Delay
- Used to monitor the Blanking area for H sync
and V sync.
t
Blue Only
- Used to switch in the order of [Off]-[Blue Only]-
[Mono]-[Off].
- Press the button to remove red and green
components from the input signal and display
blue componet only.
- Press the button again to switch to mono-
chrome mode which has no chroma signal.
[4] Display/Video
6. Menu Operations