Tuxedo FP14KO-A, Assembly & Operation Manual, Page: 9 / 27

INSTALLATION
IMPORTANT NOTICE
These instructions must be followed to insure proper installation and operation of your lift.
Failure to comply with these instructions can result in serious bodily harm and void product
warranty. Manufacturer will assume no liability for loss or damage of any kind, expressed or
implied resulting from improper installation or use of this product.
PLEASE READ ENTIRE INSTRUCTION BEFORE STARTING TO ASSEMBLE THE LIFT
STEP 1 :
(Selecting Site) Before installing your new lift, check the following:
1.
LIFT LOCATION: Always use architects plans when available. Check layout dimension against floor
plan requirements making sure that adequate space is available (See FIG. 2).
The specified safety
distances must be from front wall 63 inch (1600mm) , from side wall 39 1/2 inch (1000
mm) at least. The room ceiling must be at least 157 1/2 inch (4000mm) in height.
Fig. 2
T
O
t
2.
FLOOR REQUIREMENTS: The lift should be installed on a 3000 PSI concrete with little gradients.
hickness of concrete ≥ 6 inch (150 mm). The leveling of whole area ≤ 3/8 inch (10 mm).
r, every column shall be located on a concrete block with size at least 24*24 inch (600*600 mm),
hickness
≥
8 inch (200mm)
STEP 2 : (Unloading and Unpacking)
1. After unloading the lift, place it near the intended installation location.
2. Remove the shipping bands and packing materials from the unit.
3. Remove the packing brackets and bolts holding the two columns together. (Do not discard
bolts, they may be used in the assembly of the lift )
STEP 3 : (Site Layout)
1. Once a location is determined, use a carpenters chalk line to layout a grid for the platform
locations. (See Fig.1). Keep all dimensions square and within 1/8” otherwise a malfunction of
the lift will occur.
5
2. Before continuing with the installation it is helpful to get a visual look of the shop, and other
clearances. Also, this is a good time to drive a vehicle into the position and check for
adequate clearance.