Tuxedo FP14KO-A, Assembly & Operation Manual, Page: 11 / 27

9. Mount on the plastic slide blocks on the crossbeam.( Fig. 6)
10. Fix the lower end of the safety rack by a bolt. (Fig 7)
7
Fig 4 Fig. 5 Fig. 6 Fig. 7
STEP 6 : (front yoke )
1. Lay down the front columns. Take out the safety rack.
2. Take off the cable sheaves of the front yokes.
3. Slide the front yoke into its column ( open hole towards the platform)
4. Insert the safety rack through the yoke same as the rear cross beam.
5. Set up the front columns. Move them to the front end of the platforms.
6. Raise up the front yoke to touch the platform then rest on the safety rack. ( At least one man
to take care of the column. It is unstable at this step)
7. Line the cable through the yoke and column.
8. Bolt the yoke with the platform.
9. Fix the bolt on the lower end of the safety rack.
10. Do the same with another front yoke.
STEP 7 : (anchor the front columns )
1. Check carefully with the location of the columns and its plumb. Using a tape measure to
measure the distance between the opposite corners of the base plate on the columns. Equal
values will insure the lifting arms will be in square.
2. Using the base plate on the front column as a guide, drill an anchor hole on the back of the
column in the concrete approximately 5
1
/
2
” deep using a rotary hammer drill and
3
/
4
” concrete
drill-bit. To assure full holding power, do not ream the hole or allow the drill to wobble.
3. Anchor the front column for safety.
STEP 8 : (hydraulic system )
1. Mount on the motor pump on the column with bracket. (Fig. 8)
2. Also mount the air-release valve bracket with the pump ( Fig. 9)
3. Connect the hose from pump to cylinder with the connector supplied.
4. Fill the tank with hydraulic oil ( about 10 liters)
5. Have a certified electrician to run the 220V/60Hz single phase power supply to the motor. Be
sure to size the wire for a 25 amp circuit.
6. Mount on the air-release valve. Connect the compressed air supply through pipe supplied.