strana
27
7. DRILL MODE
Select Drill mode for drilling and other heavy
duty applications.
To select Drill mode, rotate the torque-
adjustment ring until the
17
icon aligns with
the torque indicator and clicks into position.
Drill icon
Torque indicator
8. VARIABLE SPEED TRIGGER SWITCH
To start the tool, press the switch 1, and keep it
pressed.
To switch the unit off, release the switch
The variable speed trigger switch delivers higher
speed with increased trigger pressure and lower
speed with decreased trigger pressure.
9. FULLY AUTOMATIC SPINDLE LOCKING
When the on/off switch 1 is not pressed, the
drill spindle and thus the tool holder are locked.
This enables screws to be screwed in, even
when the battery is empty and allows for the
tool to be used as a screwdriver.
10. MECHANICAL SPEED
ADJUSTMENT
The drill has a two-speed gearbox designed for
drilling or driving at LO or HI speeds.
Use LO speed for loosening or driving screws.
HI speed is better for drilling holes.
11. TEMPERATURE DEPENDENT
OVERLOAD PROTECTION
When using as intended for, the power tool can
not be subject to overload. When the load is too
high or the allowable battery temperature range
of 0-70
℃
is exceeded, the speed is reduced.
The power tool will not run at full speed until
reaching the allowable battery temperature.
12. WORKLIGHT INDICATOR
The worklight indicator 2 is lit when the trigger
switch 1 is depressed in whether the direction-
of-rotation switch 5 is at the center position
or at working time. It allows for illumination
of the work area under unfavorable lighting
conditions.
As the battery is depleted, the worklight
indicator will flush 5 times per second. Suggest
that use the tool after cooling naturally in order
to prolong service life.
As the temperature of the tool is so high,the
worklight indicator will flash slowl
y, about once
per second. Suggest that charge in time in
order not to take up your working time.
APPLICATION
WARNING:
Apply the power tool to the
screw only when it is switched off. Rotating tool
inserts can slip off.
Check and make sure the direction-of rotation
switch 5 is at the correct setting (left or right),
hold the drill firmly on the insulated grip, and
place the drill bit at the point to be drilled. Move
the drill bit into the workpiece, applying only
enough pressure to keep the bit cutting. Do not
force the drill or apply side pressure to elongate
a hole. Let the tool do the work.
NOTE:
If the bit jams in the workpiece or if the
drill stalls, stop the tool immediately. Remove
the bit from the workpiece and determine the
reason for jamming.
TOOL MAINTENANCE
WARNING:
Before any work on the
machine itself, remove the battery pack from
the drill.
1
.
Inspect bolts periodically. If the bolts loosen,
tighten them immediately, or will result in
serious accident.
2
.
Inspect tool cords periodically. If damaged,
have repaired at your nearest Authorized
Service Center.
3
.
Keep the vents clean. Clean all parts of
the tool, clean dust periodically. To prevent
- 7 -
The worklight indicator 2 is lit when the trigger
switch 1 is depressed in whether the direction of
rotation switch 5 is at the center position or at
working time. It allows for illumination of the
work area under unfavorable lighting conditions.
As the battery is depleted, the worklight indi-
cator will flash slowly, about once per second.
Suggest that charge in time in order not to take
up your working time.
As the temperature of the tool is so high, the
worklight indicator will flush 5 times per second.
Suggest that use the tool after cooling naturally
in order to prolong service life.
