turck TBIP-L...-FDIO1-2IOL Series TBIP-L4-FDIO1-2IOL, Instructions For Use Manual

Page: 46 / 165

Setting IP Addresses
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com 38
6.1 Address setting via Rotary Coding Switches
x100: sets the 100-position of the F-address
x 10: sets the 10-position of the F-address
x 1: sets the 1-position of the F-address
Fig. 14: Rotary coding switches
Switch

position
Meaning Valid for: Further

chapters
safety side non-safety
side
000 Delivery state, no valid address

Resetting the IP address yes no
s. page 42
001 -
254 IP address:
The last byte of the IP address for the safety
side is set via the 3 rotary coding switches.

Set the address switches to the desired IP
address and carry out a voltage reset.
yes no s. page 41
300 BootP

Set the address switches to 300 and carry out
a voltage reset at the device.
no yes s. page 41
400 DHCP

Set the address switches to 400 and carry out
a voltage reset at the device.
no yes
s. page 41
500 PGM

Set the address switches to 500 and carry out
a voltage reset at the device.
no yes
s. page 42
600 PGM-DHCP

Set the address switches to 600 and carry out
a voltage reset at the device.
no yes
s. page 42
900 F_Reset

Sets the device (IP addresses, parameters, etc.)
and the plugged memory chip to factory set-
tings, the content of the memory stick is
deleted.

Set the address switches to 900 and execute a
power reset at the device.

Wait for 30 seconds.

Device and memory stick are reset for factory
settings.
yes yes
Reset Device
to Factory
Settings
(page 101)
901 Erase Memory
Deletes the content of the memory chip.

Set the address switches to 901 and carry out
a voltage reset at the device.

The content of the memory chip is deleted.
yes yes
Storing a
Configura-
tion (page
23)
WINK
MS
NS
EtherNet/IP™ ETH1 ETH2
IP Address
0
9
8 7
6
5
4
3 2
1
0
9
8 7
6
5
4
3 2
1
0
9
8 7
6
5
4
3 2
1
x 100 x 10 x 1
Memory