20
21
• Start the mortar pump using
the start/stop button
I/0
(32)
:
the pump starts pumping the
slurry previously poured into
the hopper.
Adjust the pump output to the required value using the
variable-speed drive handwheel
(13)
.
When the slurry previously poured into the hopper has
been pumped out, stop the machine by closing the air
control valve
(14)
on the gun.
• Pour the mix into the hopper.
• Start the machine by opening the air control valve
(14)
on
the gun.
When no more slurry but just mortar comes out the gun,
start working normally.
The machine remote control is activated by opening and
closing the air control valve
(14)
on the gun.
Various types of gun are available for spraying materials
(see page 11).
Each gun comprises:
- a coupling to the material delivery hose
(45)
- a coupling to the air hose
(46)
- a control valve on the air hose
(14)
- an air nozzle
(47)
with or without possibility of regulation
(48)
- a spray tip
(49)
- possibly a material
shutoff valve
(50)
- and a relief valve for excess air
(51)
.
By way of general information, using nozzles and spray
tips with a smaller diameter results in a wider spraying rose
of the material and vice versa.
If ready-mixed materials are used, the vibrating sieve is
unnecessary.
A start/stop cable remote control is available as an
alternative to the pneumatic remote control.
To operate with the cable
remote control, it must be
connected to the connector
(52)
located below the control
panel.
During work, periodically check the pumping
pressure shown by the pressure gauge
(33)
located
on the pump outlet header.
51
14
45
46
47
48
49
50
13
32
52
Summary of Contents for POLI T
Page 31: ...31 ...
