turbofan 30D Series, Installation And Operation Manual, Page: 18 / 20

Appendix 1 - Oven Door Reversal
16

Refit all screw fasteners using a low-mid strength
thread locking adhesive unless otherwise stated.

Door reversal should only be carried out by a
suitably competent person.
Remove the Oven Door Inner Glass.
1. Open the oven door and
open the door inner glass.
2. Remove screw securing
inner glass retaining clip
and remove clip.
3. Lift up inner glass and
remove, ensuring that pivot
spacer is removed from
lower inner glass pivot and
retained.
4. Remove black plastic plugs
from top and bottom of
door and fit to holes where
inner glass pivots were
removed from.
Remove the Oven Door.
5. Remove the door roller catch and blanking plate from
the inside of the door and swap these over.
6. Whilst supporting door,
unscrew and remove top
door pivot bolt from top
door hinge assembly.
7. Remove door and lay on a
flat surface or workbench.
8. Unscrew screws securing
the door handle remove
door handle.
9. Remove top door hinge and
fit to bottom opposite
corner of door.
10. Remove bottom door hinge
and fit to top opposite
corner of door.
Fit Blanking Plugs.
Remove Top
Door Pivot Bolt.
Remove Top Door Hinge
Remove Handle
Securing Screws
Swap Roller Catch and
Blanking Plate over.
11. Remove inner glass latching
studs and fit to opposite
side of door using Loctite
243 to secure.
12. Turn door handle over and fit to other end of door
where hinges were removed from. Ensure Flat of
handle is to the outside.
Remove Upper and Lower Door Hinges and Door
Catch.
13. Remove bottom door pivot
bolt and spacers and fit
pivot bolt to top door hinge
assembly (as this will be
swapped over and fitted to
bottom of other side of
oven).
14. Remove the 4 blanking
screws from front of oven.
15. Remove Hinge Plate from
top of oven and fit
diagonally opposite, to
lower corner.
16. Remove Hinge Plate from
bottom of oven and fit
diagonally opposite, to
upper corner.
17. Fit screws removed at Item
14 above to where hinges
were fitted.
Remove these screws to remove
top and bottom hinges.
Bottom Door Pivot
Bolt and Spacers.
Remove screws top and bottom
and fit to where hinges removed
from.
Remove Latching Studs
Remove Screw and
Retaining Clip.