15
Main Burner Electrode Check
With the assistance of another person,
perform this Electrode Check before pro-
ceeding.
7
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily.
(for BTH2610ALP/NG)
Final Grill Assembly Step
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
Before each use of the grill, make sure the
Grease Tray is fully seated under the Grill Bowl.
CAUTION: The Grease Tray should be inspected
before each grill use to be sure there is no ex-
cessive grease buildup. Clean the Grease Tray
frequently to eliminate grease build-up and to
prevent grease fires.
Cooking Rack/Secondary
Cooking Grids
Flame Tamer
Flame Tamer Rack
Cooking Rack/Secondary
Cooking Grids
Flame Tamer
Flame Tamer
Rack
(for BTH3210LLP/NG)
Spark Electrode Tip
Spark Receiver
Spark Gap 3/16"
Gas Collector
Box
Install Cooking Components
8
Place the Flame Tamer Rack inside the Grill
Bowl. Position it onto the lower ledge of the
Bowl above the burners. Next, place the Flame
Tamers on the Flame Tamer Rack. (See the
diagrams on right)
Place the Cooking Grids on the ledge above
the Flame Tamers.
Place the Secondary Cooking Rack into the
slots on Grill Bowl Side Panels.
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and recon-
nect any loose wires.
-
-
Be sure all Control Knobs are set to "OFF" and
open the Grill Lid.
Have your assistant stand behind to the right of
the grill and look toward the front of the grill bowl.
Never
put your face inside the Grill Head.
Press the Ignitor Cap. You should hear a
"clicking" sound. Your assistant should see a
blue spark within each Gas Collector Box. If
a spark is present the Electrode Tips are
properly positioned.
If no spark is seen, the Spark Gap needs to
be adjusted as follows:
•
•
If the gap between the Spark Electrode Tip
and Receiver is more than 3/16" wide use
needle nose pliers to gently squeeze the
Gas Collector Box to narrow gap.
Recheck the Electrode again, if no "clicking"
sound is heard:
