14
Install Ignitor Battery
Remove Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor Slot with positive pole facing you.
Position the Cap and Spring over the AA battery and tighten onto Control Panel.
6
Install the Partition Panel (not included in this unit) onto the right island.
Make sure there is 22-24" of clearance between the Partition Panel and the
Tank Holder Assembly.
5
Install Partition Panel (for BTH2610ALP & BTH3210LLP Models)
Fig. 4
Tank Holder
Assembly
1"
5"
17-19"
Partition Panel
(above the Gas Tank)
5"
Vent Openings must
be at least 1/8" wide.
22-24"
21"
Ignitor Cap
Ignitor Slot
AA Battery
Spring
