![Tunze Comline Multifilter 3168 Instructions For Use Manual Download Page 13](http://html.mh-extra.com/html/tunze/comline-multifilter-3168/comline-multifilter-3168_instructions-for-use-manual_1180676013.webp)
24
25
Wasserstandsregulierung mit dem TUNZE
®
Osmolator
®
Der Infrarot-Sensor des TUNZE
®
Osmolators
®
kann
direkt an der hinteren Seite des Filters angebracht
werden. Diese Position garantiert einen optimalen
Wasserstand für die TUNZE
®
Comline
®
-Serie mit
einem sehr kompakten Aufbau (1).
Halter für Optosonde (2) vom Magnet Holder für zwei
Sensoren 3155.600 (3) mit einem Schraubenzieher
entfernen (4). Halter für Optosonde an der Comline
®
hinten oben in die Osmolator
®
-
Öffnung (5) stecken.
Arbeitssensor (mit Kabel nach oben) einführen (6),
danach bis Anschlag anheben und durch Drehen
verriegeln.
Sicherheitssensor (Kabel nach unten) auf den
kleinen separaten Magnet Holder befestigen.
Bitte beachten Sie die Hinweise in der Osmolator
®
-
Anleitung 3155, Kapitel „Befestigung des
Sicherheitssensors separat auf dem kleinen Magnet
Holder“.
Water level regulation with the TUNZE
®
Osmolator
®
The infrared sensor of the TUNZE
®
Osmolator
®
can
be mounted directly on the rear side of the filter.
This position ensures optimum water level for the
TUNZE
®
Comline
®
series in a very compact design
(1).
Remove the holder for the optical probe (2) from the
Magnet Holder for two sensors 3155.600 (3) using a
screwdriver (4). Plug the holder for the optical probe
into the Osmolator
®
opening (5) at the top rear of
the Comline
®
.
Introduce the working sensor (cable upwards) (6),
then lift up until the stop position is reached and lock
it by turning.
Attach the safety sensor (cable downwards) to a
separate holder.
Please remark the notes in the Osmolator
®
instructions 3155, Chapter “Position selection of the
sensors in the aquarium”.
Regulation de niveau avec Osmolator
®
TUNZE
®
Le capteur infrarouge de l’Osmolator
®
TUNZE
®
peut
être fixé directement à l’arrière du filtre. Cette position
garantit un niveau d’eau optimal au fonctionnement
des composants TUNZE
®
Comline
®
de l’aquarium
avec un encombrement très réduit (1).
Pour cela, retirez le support du capteur infrarouge (2)
de son support d’Osmolator
®
3155.600 (3) avec un
tournevis plat (4).
Clipsez le support à l’arrière de la Comline
®
dans
l’ouverture prévue à cet effet (5).
Montez le capteur de régulation (câble vers le
haut) (6) et verrouillez par une rotation jusqu’à
butée.
Montez le capteur de sécurité (câble vers le bas) sur
un support séparé.
Veuillez observer les remarques de la notice
Osmolator
®
3155 au chapitre „Placement des
capteurs“.