3
Safety Instructions
1. For your safety, please read these instructions carefully before installation or
operation.
2. Important: Please comply with the following instructions before using your Tumo-Int
wind turbine.
2.1
please read these instructions carefully before use.
2.2
Safety instructions before installation
：
2.2.1 Install Tumo-Int wind turbine on sunny day.
2.2.2 Do not install Tumo-Int wind turbine during dusty day with more than 10 m/s wind
speed.
2.2.3 Wear wet gloves or clothes are prohibited.
2.2.4 Install and maintain Tumo-Int wind turbine under professionals guidance, or
contact distributor.
2.2.5 Do not use too thin or poor quality cables, use original cables as far as possible in
order to avoid leakage or fires and line losses.
2.2.6 Non-professionals do not open controller and inverter casing.
2.2.7 Install grounding device in accordance with application standard and installation
instructions.
2.2.8 Battery may be sparks flying while wiring, make sure that no inflammables the
work environment nearby.
2.2.9 Do not place the controller, inverter and battery in damp, rain, vibration, corrosion
and strong electromagnetic interference environment, the places in direct sunlight, near
heater or other heat sources are not allowed, either.
2.3
Selection and installation requirements of controller, battery:
2.3.1 Controller specification should be matched with voltage, power and current of the
battery, solar panel, wind turbine and load.
2.3.2 Controller and battery should be put in a power housing cabinet, and the housing
is located in ventilated place where people are not easy to touch.
2.3.3 Controller and battery must be installed in accordance with corresponding electric
equipment installation standard and operation regulations of manufacturer.
2.3.4 Power housing cabinet is placing near people living room, adoption of sealed
battery is far more safe.
2.3.5 Negative pole of battery should be in good grounding.
2.4
Wiring requirements:
2.4.1 Connections between components in the system should be fixed and reliable, plug
and socket are not allowed for the connection.
2.4.2 The Wind system’s power output terminal must be firmly fixed with consumption
load terminal, or the wind system’s power output terminal adopted of using power
socket.
2.4.3 Do not use two-way plug for the connection of wind system’s output terminal with
consumption load terminal.
Summary of Contents for 3000W 5 Blades Wind Turbine
Page 22: ...1 ...
