KL 2500/3000
21
Adjustment example for sowing oats 200 kg/ha
•
Check in the upper right corner of the chart for correct position of the bottom
valves in item "cereal". The correct setting is position 2.
•
Choose line "oats".
•
Check the gear ratio which is to be "I", pin on the feeding shaft Fig. 6
•
Start reading from the left corner of the chart from point 200 kg/ha
•
Follow the horizontal line (arrows) to the point where this line and the line "oats"
intersect
•
Go vertically from the intersecting point to the lower scale where You can see
that the right hand wheel position is 5,7.
Adjustment example for sowing rape 14kg/ha
•
Check that in the upper right corner of the sowing chart the correct bottom valve
position is given to be "1".
•
Study the small sowing chart.
•
Check the gear ratio, which is to be II, pin on the intermediate shaft Fig. 7
•
Start from the left corner of the little sowing chart from point 14 kg/ha.
•
Move horizontally along the 14 kg/ha line to the right until You reach the
intersection point of that line and the line"rape"
•
From the intersection point go vertically to the lower scale which shows that the
correct setting of the hand wheel position is 2,1.
Adjustment example for JAPAN NPK fertilizer mixture 700kg/ha
•
Check in the left side of the fertilizer sowing chart (Fig. 10) that the correct
bottom valve position for granulated fertilizer is 3.
•
Start from the left corner of the chart from point "700 kg/ha".
•
Move horizontally along the 700 kg/ha line to the right until You reach the
intersection point of that line and the line "Japan fertilizer".
•
From the intersection point go vertically to the lower scale. The right positioning
for the hand wheel is 7,2.
Caution! Calibration tests should be carried out after any
adjustments in order to ensure the correct seed and fertilizer
amounts. Calibration test rotation amounts dependent on
machine type can be seen in the upper left-hand corner of the
sowing chart, in the "Calibration test" section.
