KL 2500/3000
15
If dirt accumulates on the feeding device or seed characteristics change, i.e. because of
the seed dressing function, the actual feed amount may change significantly from its
original value. We recommend cleaning as needed, but at least on a daily basis. Rollers
can be cleaned by adjusting the feed amount to zero and then again to the desired
adjustment value. In such cases the previously stated adjustment rule should be kept in
mind - i.e. rotate first 1/2-1 times beyond the desired adjustment value. The real feed
amount can be checked by repeating the calibration test.
CAUTION! The Hand-wheel must not be forced to a zero-
position. Simultaneous rotation of the feeding axis will ease
the adjustment.
Changing the gear ratio of transmission: cereals & peas to small seeds
•
Remove the pin from feeding shaft. Fig. 6, part 1
•
Fasten the pin to the intermediate shaft. Fig. 7, part 1
•
NOTE! The transmission can be damaged if there is two pins simultaneously on
the feeding shaft and intermediate shaft.
Figure 6. Transmission set for seeding of cereal and peas
