9
Step 4
• Once the change has been made and the plate restarted, print the calibration piece again
• Follow these steps until you are satisfied with the result
Step 3
• In File Manager / System / config.g
• In the Tools section modify the parameter U and Y if necessary
• To put decimals use “. “
• Supports 2 decimal places
Print Mode Selection
• To print with the Left head we will select “Left Extruder Only”
• To Print with the Right head we will select “Rigt Extruder Only”
• If we want to print with a double head, either a two-color piece or a single piece and a support material, we will use “Dual Extruder”
• If we want to replicate a piece with the second head we will use “Mirror Mode” this will replicate everything that the Left head
prints
