FIG. 5
Maneuver the two
Guide Rods (#4)
into the holes on the
bottom side of the
Guide Rod Retainer (#5)
. Next, secure the
Guide
Rod Retainer (#5)
along with the two captive
Guide Rods (#4)
to the
Weight Stack Frame (#1)
using two Hex Head Cap Screws 1/2-13 X
3 1/4 (#64), four Flat Washers SAE 1/2” (#29), and two Nylon Insert
Lock Nuts 1/2-13 (#22).
FIG. 6
Locate the Selector Pin w/Coil (#66) and slide the ring over
the
Selector Bar (#9)
as shown above.
FIG. 7
Connect the
Cable (#38)
to the
Top Plate Selector Bar
(#9
)
by threading the Finished Hex Nut 1/2-13 (#59) and inserting a
Split Lock Washer 1/2” (#57) to the Cable Hex Tap Bolt 1/2-13 X 3
(#56). Then, thread the Cable Hex Tap Bolt 1/2-13 X 3 (#56) to the
threaded socket of the
Top Plate Selector Bar (#9).
Loosely Fasten:
Do not completely fasten this hardware as-
sembly at this time, as it will be completely fastened later in
the assembly process.
Note:
Refer to
Fig A
on fold-out page 11 for further detailed il-
lustration of this assembly.
FIG. 8
Adhere the Decal Weight Numbers (#67) to the Weight Plates
(#8) in the corresponding order. Begin with the 20 at the top, 30 next,
and so on.
3
5
1
4
4
66
9
9
66
56
59
57
9
67
8
67
8
38
SP-401 Supine Bench Press
