www.tuffstuffitness.com
CG-9503 MULTI-PRESS
19
Weight stack label and lubrication instructions
1� Wipe front surface of weight stack with rubbing alcohol and wipe dry�
2� Peel off back sheet (adhesive side) from label (#87) and make sure that the label remains
attached to the application tape�
3� Line up left edge of label sheet with outside edge of weight holes�
4� Line up the first label to hole on top plate�
5� Make sure label is straight and slowly press into place�
6� Gently remove application tape and rub each label firmly against the weight stack�
7� Allow labels to stand for 2 days to allow adhesive to cure fully�
8� Open the lube package provided and apply a thin film of lubricant around the first 3 inches
of the guide rods above the top plate�
9� After the cables are installed, do a set of reps to spread the lubricant thoroughly�
Step 5 Assembly List
Item #
Description
Qty.
6
GUIDE ROD 3/4 RD X 50 3/8
2
15
SELECTOR PIN W/COIL 3/8 X 4 GOLD KNOB
1
21
10 LB TOP PLATE W/ADJUSTABLE SELECTOR BAR
1
28
BLACK NYLON PULLEY 3/8 X 1 X 3 1/2
1
39
FLAT WASHER SAE Z/P 3/8”
4
45
HEX HEAD CAP SCREW GR-5 Z/P 3/8-16 X 1 1/4
2
46
HEX HEAD CAP SCREW GR-5 Z/P 3/8-16 X 1 3/4
1
57
NYLON INSERT THIN PATTERN LOCK NUT Z/P 3/8-16
1
61
RUBBER DONUT 3/4 X 2 1/2
4
68
SPLIT LOCK WASHER Z/P 3/8”
2
74
10 LB STEEL WEIGHT PLATE BLACK 4 X 10
19
87
LABEL-NUMBERS 10-200 LBS/KGS 7/8 X 3 YELLOW
1
NOTE:
1� TOP PLATE LABEL GOES ON HOLE OFF CENTER AS
SHOWN� LABEL WILL COVER HOLE ON CENTER�
87
Summary of Contents for CG-9503
Page 27: ...www tuffstuffitness com CG 9503 MULTI PRESS 27 Notes...
Page 28: ......
