3 |
P a g e
1.
1.
1.
1.
TONNEAU COVER FITTING
TONNEAU COVER FITTING
TONNEAU COVER FITTING
TONNEAU COVER FITTING
NOTE
Read entire instructions prior to start.
1.1 BASIC TOOL REQUIRED
1.1 BASIC TOOL REQUIRED
1.1 BASIC TOOL REQUIRED
1.1 BASIC TOOL REQUIRED
Drill, 4mm Drill Bit, Rivet Gun, Marking Pencil / Pen
1.2 TONNEAU COVER INSTALLATION PROCEDURE
1.2 TONNEAU COVER INSTALLATION PROCEDURE
1.2 TONNEAU COVER INSTALLATION PROCEDURE
1.2 TONNEAU COVER INSTALLATION PROCEDURE
1.
Using two pieces of dowel, join the 3 aluminium rope tracks together. Place the other 2
pieces of dowel in the ends of the now joined rope track.
2.
Rest the aluminium rope track on the side rails, and push forward
. Figure 1
to the
vertical face of the tub.
3.
Using a 4 mm drill bit, drill 6 holes 50mm from the end of each of the aluminium rope
tracks into the front of tub.
4.
Using a 4 mm drill bit, drill 6 holes 50mm from the end of each of the aluminium rope
tracks into the front of tub.
5.
Slide the front of the tonneau cover through the aluminium rope track section.
6.
To fit the bar brackets, measure 700mm back from the inside front edge at the top of
the tub and place them as shown in
Figure 2
. (10mm down from top edge of tub) Drill
and rivet using two large rivets for each Bar Bracket. Install the support bar according to
the supplied instructions.
7.
Neatly lay tonneau out over support bar and tub in the installed position. Fasten all
collars around sports bar legs with the press studs.
8.
To fit the rope buttons to tub, use the panel crease in both the tailgate and side panels
as a reference line,
See Figure 3
. Starting with the
tailgate,
line up vertically each
button to each ring grip and drill and rivet each button to the crease, so that the top
edge of the button is in line with the top edge of the crease. For the
side panels
, follow
the same procedure as with the tailgate, drill and rivet buttons alternating from one side
to other side of the tub.
