6 |
P a g e
3.
Remove tonneau and drill the marks with a 4 mm drill bit, place the lock bracket in position and
rivet.
3.
3.
3.
3.
MULTI
MULTI
MULTI
MULTI----FIT SUPPORT BAR
FIT SUPPORT BAR
FIT SUPPORT BAR
FIT SUPPORT BAR
The Tuff Tonneau Multi - Fit Support Bar is designed to fit
almost all Utes on the Market, from Suburu Brumbys to
Cab Chassis aluminium trays.
Part No: BARADJ
2.1
2.1
2.1
2.1 BASIC TOOL REQUIRED
BASIC TOOL REQUIRED
BASIC TOOL REQUIRED
BASIC TOOL REQUIRED
Drill, 4mm drill bit
2.2
2.2
2.2
2.2 MULTI
MULTI
MULTI
MULTI----FIT SUPPORT BAR
FIT SUPPORT BAR
FIT SUPPORT BAR
FIT SUPPORT BAR CONTENTS
CONTENTS
CONTENTS
CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
- 1 x Tonneau bar sheath
2.3
2.3
2.3
2.3 FITTING
FITTING
FITTING
FITTING MULTI
MULTI
MULTI
MULTI----FIT
FIT
FIT
FIT BAR
BAR
BAR
BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket
holders with the holes facing to the ground (so the grub screws don’t rub against the tonneau),
as shown above and then with a white pencil make a mark through the small holes of the
hollow bar onto the solid ends. This is where you will drill a hole to the depth of about 1-2mm
(do not go any further)
2.
Join the pieces back together and screw grub screws through the hollow bar into the holes that
you drilled.
Make sure you do not over tighten the grub screws
. Then place the
tonneau sheath over the bar to stop the bar wearing against the tonneau. Refit the bar. You
may kink the bar in the middle to give it some extra height to assist with water runoff.
Warning if you do not fit the tonneau sheath over the bar, the tonneau cover will quickly wear
through which is not covered by warranty.
Your Tuff Tonneau is now ready for work.
