Smith-Half Cage Series
3
IG. 3
Next, attach the Decal Numbers 1-20 (#64) to both
Front
Uprights (#4)
. Center the number 20 with the second adjustment hole of
he
Front Upright (#4)
. A great way to make sure you don’t trap any air
ubbles under the decal is by using the wedge method. Press the side of
our index fi nger against the decal and as you slide your fi nger down, with
he other hand, slowly remove the rest of the backing off the decal.
1
2
4
4
4
64
4
4
64
FIG. 2
Attach the two
Front Uprights (#4)
to the two
Bottom
Frames (#1, #2)
, in the position as shown above, and secure them
into place using four Hex Head Cap Screws 1/2-13 X 4 1/4 (#78), fou
Flat Washers SAE 1/2” (#70), four Flat Washers 1/2 X 1 3/4 (#68), an
four Nylon Insert Lock Nuts 1/2-13 (#101).
Note:
Make sure to assemble the
Front Uprights (#4)
with
the oval hole pattern towards to the back of the Unit.
FIG. 4
Next, slide the
Bar Safety Spotters (#17)
onto the
Fron
Uprights (#4).
Then, slide the
Bar Holders (#18)
onto the
Fron
Uprights (#4)
as shown above.
18
4
17
4
18
17
IG. 1
Locate the two
Bottom Frames (#1, #2)
and the
Bottom
Cross Brace (#3)
and attach them, in the position as shown above,
sing four Hex Head Cap Screws 1/2-13 X 3 1/2 (#77), four Flat
Washers SAE 1/2” (#70), and two Nylon Insert Lock Nuts 1/2-13
#101).
Caution
: It is strongly recommended to use another person
in assisting with the following assembly.
2
3
1
TBU-335
TBU-335
TBU-335
THC-43C