BUILD INSTRUCTIONS
Tuff Birds
Super Tough Wings & Planes
Use CA or Hot Glue to install the Winglets at the
Wing Tips. Align the Winglets so they are flush
from the leading edge and as centered on the
tips as possible.
Servos need to be installed as far forward as
possible. Ensure that the linkage is perpendicular
to the elevon hinge line. Install the control horn so
that the hole is on top of the hinge line.
9. Install Servos & Linkages
11. Install Winglets
10. Assemble Motor Mount
This is the most cruicial step . CG of this wing
should be
130MM from the nose tip
. Adjust the
placement of battery to get the CG to this
position. Flying wings are very sensitive to CG,
and if the CG is off by more than 5MM the plane
will not fly properly.
12. Check CG
Assemble the Motor mount using the 4 parts as
shown. The small arrows marked need to be
facing towards the top. Use CA to Glue the parts
together. Install the motor mount on the wing,
keeping it as centered as possible.
130 MM
4
Micro BEE
600MM Flying Wing
90°
90°
Ver 1.0 12 May 2018
