Eco Sweeping Machine
3
.5 Detachment
During detachment or decoupling, special caution
must be exercised.
Carry out modifications on the sweeping machi
-
ne only the hydraulic drive is switched off. Pull the
ignition key and secure the carrier vehicle against
unintended restart and movement!
During the detachment, follow the operating
manual of the carrier vehicle! Only one examp-
le is described and shown here for each case.
• Only detach the sweeping machine with the dirt collec-
tion vessel closed and empty.
•
Park the sweeping machine on a firm and level surface in
a dry and clean place and secure it against rolling away.
Accident hazard! Ensure a secure standing of the
sweeping machine.
• Disconnect hydraulic hoses at the vehicle and put them
onto the sweeping machine, together with the bowden
control.
Accident hazard! Hydraulic hoses and bowden con-
trol are a tripping hazard on the ground. Put the hy-
draulic hoses and the bowden control across the
sweeping machine.
Seal hydraulic connector barrels with dust caps.
Soiling leads to damage on the hydraulic system.
• Lower the Eco sweeping machine until all castor wheels
touch the ground.
• For open sweeping machines, place the two supports on
the sweeping machine frame onto the ground and se-
cure with the clamping T-bolt.
.5.1 -point linkage - Detachment
The safety instructions in Chapter 3.5 are
mandatory!
• Pull out the clamping T-bolt (3) of the support (4). Place
the support onto the ground and secure it with the clam-
ping T-bolt (1), if present.
• Remove the 3-point linkage rods from the carrier vehicle
on the 3-point linkage of the sweeping machine.
Drive carrier vehicle away, backwards in the
case of frontal attachment and forward in
case of rear attachment.
NOTE
ATTENTION
ATTENTION