Tube-Line BALE BOSS II, Operator'S Manual

Page: 18 / 71

Bale Processor Boss II -
Section 4 - Processor Pre-operation 4-1
Safety first! Read and understand the safety instructions
(pg.2-1) before operating.
Before First Use
• Inspect the attachment for shipping damage. If damage does exist, do not operate until the
damaged parts have been replaced or repaired. Replace any damaged parts before operating,
call dealer for Warranty information and/or claims.
• Check air pressure in tires – 35lb. (15.9 kg).
Adjustments
• Machine is assembled complete from the factory less hitch mountings.
• Processor hitch can be moved up or down to suite power
unit drawbar. Remove bolts and nuts from hitch, raise or
lower hitch to desired position and refasten hardware. Deck
of processor should sit level for best operation. Improper
hitch adjustments may cause separation from the PTO
drive-line when operating on uneven terrain.
• Conveyor chain should be adjusted to allow chain slack 1”
(2.54 cm) to 1 1/2” (3.8 cm).
•
Deflector shield angle can be adjusted by removing lock pin
and moving bar to different hole and/or different pin.
• Check air pressure in tires – 35lb. (15.9 kg)
• If machine is equipped with optional knife kit, it can be
lowered or raised to suite your operation and/or feed
material.
• Flow controls on front of processor adjust the ram (right side)
and top beater (left side). Moving lever left decreases flow to
slow that function, right increases flow - speed up function.
Twist knob to tighten or loosen lever position.
Section 4 - Processor Pre-operation
Top Beater
Flow Control
Ram Flow Control