TTMC BS-315G, Operation Manual

Page: 5 / 18

4
alternating current as low voltage (24V). The equipment is protected against
splashes of water and dust.
C. Protection of the system against short circuits is ensured by means of rapid fuses
and grounding; in the event of a motor overload, protection is provided by a thermal
probe.
D. In the event of a power cut, the specific start-up button must be reset.
E. The machine has been tested in conformity with European Standard.
1.3 Emergencies according to European Standard “2006/42/EC”.
In the event of incorrect operation of danger conditions, the machine may be stopped
immediately by pressing the red emergency button.
The casual or voluntary removal of the blade cover of the flywheels causes the
stepping-in of a interlock switch that automatically stops all machine functions.
Note: resetting of machine operation after each emergency stop require specific
restart button.
2. Description of machine
2.1 Description of machine and its components
The band sawing machine produced by us has a sturdy frame made from welded and
painted sheet-steel. The upper surface is designed to allow the complete draining
away of the cutting fluid. The band holding bow is made of cast-iron and has generous
dimensions
，
providing the cutting unit with the necessary strength and precision. The
vice unit is made of cast-iron and clamps the material to be cut securely. The bar-stop
device allows the length required to be preset and a constant level of performance for
repeated cuts. The blade-holding bow is firmly attached to a reduction unit built onto
the motor and to the base by means of a joint which allows 60° and 45° rotation to the
right and left. This joint also allows the cutting movement to advance manually or by
falling.
The coolant pump is fitted to the machine base. The main switch is located on the
front panel. The choice of one of the two motor rotation speeds and therefore cutting
speed is carried out by the main switch. The front panel is also fitted with an
emergency stop button and a START button. The control lever
，
fitted with an
ergonomic hand-grip and activation button with safety release action, reduces fatigue
during operation to a minimum. The blade is protected by a guard with interlock which
covers the upper area and the hand wheels and by two adjustable lower guards which
protect the operator from ejected shavings and coolant. The machine is supplied with