Product HandBook
ReelStrike
™
& Strike
™
1800 816 277
www.tti.com.au
13
ReelStrike & Strike Operating Instructions
Before first use
Your ReelStrike & Strike Spot Spray Unit is delivered fully assembled and ready to be fitted onto the
vehicle. Before use, it needs to be set up using the following instructions:
•
Complete the warranty registration online at ⦁ www.tti.com.au/warranty-registration, or use the
Warranty Registration Card at the back of this handbook.
•
Store this handbook, along with the Tank Quality Check Form and pump unit’s manual in a safe and
easily accessible place for future reference.
•
Read and thoroughly understand this handbook, paying particular attention to all safety requirements,
before using the ReelStrike & Strike for the first time.
•
Check that all fittings, valves, hoses and electrical leads are secure following transit, and are not
damaged in any way.
•
Inspect the tank for any damage or abrasions that may occur during transit.
•
Position your ReelStrike & Strike unit onto the vehicle and mount securely, either using tie-down straps
to suitable points on the steel frame or other suitable devices, refer to Figure 2 and Figure 3. The tie-
down straps must be rated to at least the total mass of the unit when filled with fluid. Alternatively, the
integrated tank frame may be bolted to the vehicle.
CAUTION: The unit must be securely mounted to the vehicle. Failure to do so may
result in the unit moving or falling off the moving vehicle. Warranty is conditional on
the unit being correctly mounted.
CAUTION: Ensure any electrical connections are configured correctly to prevent
shorting or reverse polarity. Warranty is conditional on the electrical systems being
correctly connected.
WARNING: The operator must fully understand all aspects of this handbook. Do not
operate the ReelStrike & Strike unit if you are unfamiliar with its operation until you
have read this handbook.
Summary of Contents for ReelStrike
Page 27: ......
