TTA TIANNONG M6E-1, Manual

Page: 51 / 56

Copyright © 2017 TTAAll Rights Reserved. Appendix Implication of indicator light
50
①
Altitude correction:Control the flight altitude by the throttle joystick, “up” for the
drone to rise, the “down” for the drone to set ;
②
Correct the the rudder to control the direction;
③
Fix point A:while the drone moving from point B to Point A,push up the pitch stick to
make point A 1m closer to point B,push down the pitch stick to make point A 1m
away from point B.
④
Fix point B:while the drone moving from point A to Point B,push down the pitch stick
to make the point B away from point A,push down the pitch stick to make point B
1m closer to point A.
5) Shut Down and Quit
①
When set the “no pesticide” action to self-hovering or return,in AB mode this
function still
works.
②
When set the “low battery” action to return,in AB mode the this function still works.
③
After the spraying work is done,AB mode can be shut down by switching into
altitude mode.
6) To return to the breakpoint, shut down the AB mode auto-controlled or manual-
controlled. After filling the pesticide in the tank and taking off,switch SA (flight mode)to
AB mode directly ,the drone would return right to the breakpoint.
2. Remove Point A and B
Move stick SD (AB mode) for 4-5 times rapidly,LED alternately flash red green and
yellow,AB mode removed. Without removing last AB point,can not set new AB point.
3. Set the Interval Width
From the software->Flight parameters to set the spraying width and working speed
Attention:
1) Be sure to start AB mode within turning on the pump and agitation function working.
2) Be sure it is at least 10 meters away from point A to point be.
3) Every time recording point A and B,be sure to wait until the drone self-hovering
steadily in GPS mode.
4) Without removing last AB point,can not set new AB point.