Attaching the SnapNType keyboard to your iPAQ
1) Hold your iPAQ face up in the palm of one hand and the SnapNType keyboard
face up in the other hand.
2) Make sure your iPAQ will not slide relative to the protection pack.
3) Slide your iPAQ into the SnapNType keyboard until the connector latches
securely.
(see fig. 1)
1) Quit all programs and perform a soft reset.
2) Tap
Start
then select
Settings
.
3) Tap on the
System
tab and then select
Remove Programs
.
4) The list of installed program will pop up in the
Program in Storage Memory
list.
5) Tap
iPAQ SnapNType
, then tap
Remove
.
6) Tap
Yes
to confirm removal of SnapNType software.
You need to reinstall the SnapNType software before you can use the SnapNType
keyboard again.
Reinstalling or upgrading the SnapNType Softwore
To reinstall or upgrade the SnapNType software, you must first remove the existing
software by following steps outlined above. Then follow the steps outlined in the
Software Installation Section.
3
Removing the SnapNType Keyboard Software
Follow these instructions if you want to remove the SnapNType software from your iPAQ: