3/14
*For TKC91 (closed type), the arms (with hinge) and lock stays are not interchangeable.
㩷 䊶
䊶
Removing an arm on the end
1) The arm has a hook on one end and a hinge (separate part) on the other, as shown below. First, insert a
screwdriver about 7mm into the release hole on the flat side of the hook end (the left side in this diagram) and
twist to lift the arm.
㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷 㩷
Flat hole side
2) Insert fingers into the space under the lifted arm and lift and hold up. Next, insert the screwdriver slightly
between the groove on the top of the link and the underside of the arm and pull the screwdriver down to
release the hook.
3) Hold the end of the arm and using the hinge side as a base push down while twisting to lift arm up.
To remove just the arm, pull straight up with the arm in a standing position to remove. It will pull out easily,
leaving only the hinge behind.
4) To remove the hinge remaining on the link, insert a screwdriver into
one of the two release holes and twist.
