TST-770 WSD Full Line Manual-RevA
© 2021 Truck System Technologies and Pressure Systems International Inc. All Rights Reserved Worldwide.
(770) 889-9102 M-F 9-8pm, Sat 9-2pm EST
Page 29
SENSOR INSTALLATION TO WHEEL - INTERNAL SENSORS
IMPORTANT:
Sensor should be installed 180 degrees from the tire
valve stem.
See Figure 5.
CAUTION:
MAKE SURE THE SENSOR BAND IS CORRECTLY
INSTALLED ON THE WHEEL HUB AND DOES NOT MOVE LATERALLY
OR ROTATE.
See Figure 5.
5. Tighten the band clamp on the wheel hub. Ensure sensor does not move laterally or
rotate on wheel hub.
See Figures 2, 4 and 5.
IMPORTANT:
To avoid damage to the tire bead as the tire is
mounted to the wheel:
1) On SCREW-MOUNTED SENSOR
, trim excess band. Do not let the
trimmed end of the band protrude away from the wheel.
See Figure 2.
2) On SLIDE-ON SENSOR
position the sensor to secure the tail.
See Figure 4.
6. Torque the band clamp screw to 40 in-lbs (4.5 Nm).
See Figure 6.
7.
Install the tire onto the wheel and inflate to the manufacturer’s recommended pressure.
8. Check the tire balance per the tire balance machine instructions.
9. Install the wheel/tire assembly onto the vehicle per manufacturer’s instructions.
Figure 5: Internal sensor installed orientation
180º
VALVE
STEM
INTERNAL
SENSOR
ORIENTATION
CORRECT
POSITION
INCORRECT
POSITION
8
4
IMPORTANT:
Sensor should be installed in the center
“well” of the wheel 180 degrees from the tire valve stem.
Figure 6: Band clamp screw torque
TORQUE THE
BAND CLAMP
SCREW TO 40
IN-LBS (4.5 NM).
Back To
