
21
22
1
2
1
2
Whole-milled clamps allow to clamp a knife with a single screw, use a 4mm wrench for this purpose.
Prevent overclamping.
6
. To install the abrasive stone, loosen the steel fixing thumbscrew on the far stone clamp.
The distance between stone clamps should be 10 - 12mm less than the abrasive length.
Tighten the fixing thumbscrew.
6. SETTING THE SHARPENING ANGLE, PARKING
For convenience, you can “park” the abrasive holder when not actively sharpening.
As shown below, place the parking foot on the bottom of the hinged unit.
1. Either use the built-in angle indicator, or for more precision, install a digital protractor in the
location pictured (the flat just above the pivot-arm tension adjuster) and zero.
2.
Install a stone in the holder and lean it against the blade. Put the digital protractor on the
abrasive holder (stone must be centered on the blade edge). The thumbscrew on the far holder
clamp is steel, to accept the magnet on the protractor. Rotate the large main angle adjustment
wheel to set the desired sharpening angle.
Far stopper
Near stopper
Pull on the near stone clamp to release the abrasive
Summary of Contents for K03
