TSIAKMAKIS BROS arctica, User Manual, Installation & Operation

Page: 8 / 52

I N S T A L L A T I O N I N S T R U C T I O N S
6
the right draught and the avoidance of liquidation of the
exhaust gas in the internal of its walls.
►
Every chimney should be connected to exclusively one
appliance (fireplace, stove, boiler, etc).
►
The internal diameter of the chimney should be consistent
with the specifications of the manufacturer.
►
The profile of the chimney is advised to be circular because
by this way the smooth flow of the exhaust gas is assisted,
the friction is eliminated, and the attachment of burn
products (smog, tar) at the walls is avoided.
►
In case of square or rectangular profiles, the corners should
have a radius ≥ 20mm.
►
The height of the chimney should be ≥ 3,5 m from the top of
the device and where a corner is needed to be constructed,
this should be ≥ 45 °.
The common use of the same chimney with other
appliances is prohibited.
No passing of water pipes, air conditioning or power
cables inside the chimney is permitted.
TSIAKMAKIS BROS CO assumes no responsibility in
case of injury or property damage if the installation
instructions of the chimney are not followed.
Chimney outcome (hat)
The chimney ending (hat) is the device at the end of the
chimney and is used to prevent the inflow of foreign bodies
inside the chimney and the smooth flow of the exhaust gases to
the atmosphere.
The hat should: