buyTSI.com - 800.223.4540
1.
Thoroughly read this manual before using this machine.
2.
Only personnel trained should operate this machine.
3.
Personal Protective Equipment must be used including safety glasses.
4.
Keep bystanders and children out of the work area while operating this tool.
5.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted
(Including warning label). If the unit appears damaged in any way, is missing parts, or operates
abnormally, it shall be removed from service immediately. All units that have been dropped,
impacted suddenly, or dented should be removed from service.
6.
Never wet the motor, electric switch, or components. Cover these items if machine is to be
washed.
7.
Always disconnect electrical power before attempting any maintenance.
8.
Do not leave unit “ON” and unattended.
9.
CAUTION: Operation of this machine for use other than cutting tires is strictly prohibitied.
Safety Requirements
Set-Up Instruction
1.
Choose a non-slip surface that is level and has at least 5 feet around the footprint of the unit
to prevent injury from flying debris. To uncrate the machine, cut the bands and remove the
sidewalls and top of the crate. Unbolt the unit from the pallet and remove.
2.
Remove plug in oil reservoir and install breather cap. See maintenance for hydraulic fluid type
and recommendations.
3.
Check fluid levels for gas engines.
4.
For electric units refer to page 6 of this booklet for required power supply input.
5.
Motor rotation must be clockwise when looking at end of motor. If motor runs counter-
clockwise reverse the wires as indicated on the motor plate diagram.
6.
It is advised to use the holes in the mounting base angles to properly secure this unit for
operation.
