TSI Incorporated Certifier FA Plus, Operator'S Manual

Page: 30 / 63

20 Certifier
®
FA Plus Test System
2.3.1 Measurement Selection
Figure 19. Measurement Selection Screen

To add a parameter to the Parameter Screen, touch the parameter and
then touch the right direction arrow. The available parameters change
depending on what module is attached.

To remove a parameter from the Parameter Screen, touch the parameter
and then touch the left direction arrow.

To move a parameter higher on the Parameter Screen, touch the
parameter and then use the up and down direction arrows.

To change the gas calibration used, touch the gas dropdown list and select
the desired gas.
Note: If the gas selection Air/O
2
Mixture is selected but no oxygen sensor
is plugged into the Model 4081 high flow module, then the high flow
module will use the internal air calibration only. No corrections for
oxygen concentration will be made if the oxygen sensor is not
plugged into the flow module.