24
Printer Initialization
Printer initialization sets printer parameters to default values. And it will not clear downloaded files resident in flash memory.
Please follow the steps below to initialize the printer:
1.
Turn off the printer power > Hold down the
PAUSE
and
FEED
buttons > Turn on the printer.
2.
Do not release the buttons until the three LED flash in turn.
Note: Printing method (thermal transfer or thermal direct printing) will be set automatically at the activation of printer power. When
printer initialization is done, sensor sensitivity will be reset to default. Sensor calibration is required before printing labels.
Printer configuration will be restored to defaults as below after initialization.
Parameter
Default setting
Speed
76.2 mm/sec (3 ips)
Density
8
Media Width
4” (101.6 mm)
Media Height
4” (101.6 mm)
Sensor Type
Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset
0
Post-Print Action
Tear mode
Serial Port Settings
9600 bps, none parity, 8 data bits, 1 stop bit
Code Page
850
Country Code
001
Clear Flash Memory
No
Summary of Contents for TTP-244 Pro Series
Page 40: ...36 9 Revise History Date Content Editor ...
Page 41: ......
